Camcorders and Camera Heads

Panasonic LUMIX DMC-GH4 Kit | DMC-GH4EB Lumix G Compact System Camera (body only) & DMW-YAGH Interface Unit Kit

Panasonic LUMIX

DMC-GH4 Kit

DMC-GH4EB Lumix G Compact System Camera (body only) & DMW-YAGH Interface Unit Kit

Product Code:

Product Discontinued

Replaced by

Panasonic LUMIX LUMIX DC-GH5S
LUMIX DC-GH5S

4K Mirrorless ILC Camera Body with 10.2 Megapixel High Sensitivity MOS Sensor

When attached to the GH4, the DMW-YAGH provides 2 XLR inputs with independent volume control. There is also an audio level display monitor and +48V of phantom power. 

The interface adds huge functionality to the GH4. It provides four BNC connectors - two 3G-SDI capable and two HD-SDI capable, allowing for quad-link SDI 4K video in 4:2:2 10-bit, dual-link 4:2:2 10-bit 1080p up to 60 fps, or four simultaneous 1080p streams up to 30 fps - all with timecode.

The Interface Unit also has a BNC connector for timecode input. For power there is a professional 4-pin XLR 12VDC input.

Panasonic DMC-GH4

  • Highest quality shooting experience, in 4K
  • High quality, high sensitivity sensor: 16.05-megapixel Digital Live MOS Sensor
  • Micro 4/3 lens mount
  • 1024x768 OLED panel
  • HDMI 1.4a outputs 4K or 1080 streams
  • Use with UHS-3 SD cards

Interface Unit - DMW-YAGH Kit

  • Provides 2 XLR inputs
  • Dual independent volume control
  • 4 x BNC connectors: 2 x 3G-SDI capable and 2 x HD-SDI capable
  • 1 x BNC connector for timecode input
  • 4-pin XLR 12VDC input
  • Power Supply not included

AG-GH4 Ver 2.6

The following bugs are fixed

  1. When the camera is used with the Battery Grip, an error message pops up if the remaining power of the battery in the Battery Grip is low.
  2. With a use of Panasonic H-RS100400 (LEICA DG VARIO-ELMAR 100-400mm / F4.0-6.3 ASPH. / POWER O.I.S.) or some Olympus interchangeable lenses, the monitor blacks out when the user tries consecutive shooting in manual mode in AFC setting.

AG-GH4 Ver 2.5

  1. Post Focus
    The Post Focus is a special function that enables users to select in-focus point even after shooting.
  2. 4K PHOTO
  3. Three 4K PHOTO modes: [4K Burst] [4K Burst Start/Stop] [4K Pre-Burst] are added to help users capture the unmissable moments and users can choose a best shot with easy, intuitive touch-control operation after shooting.
  4. Consecutive shooting with flash burst is available when Panasonic External Flash DMW-FL580L or DMW-FL360L is attached.
  5. AF can be turned ON during video recording. [AF-ON] function can be uesd during video recording.
  6. The accuracy of digital red eye correction in the RAW development is improved.
  7. The time lag of stop signal transmission through HDMI is adjusted to make the length of the recorded contents same either on the SD Memory Card or on the external recorder via HDMI.

AG-GH4 Ver 2.4

  1. V-Log L function is added. To enable this function, AG-SFU41 Upgrade Software Key is needed to be purchased separately and to be used for activation.
    The activation function will be added by the update to Ver. 2.4.
    Activation website for AG-SFU41.
  2. Interval REC function is improved so that, even if a recording interval is short, pause and end operations can be performed using Fn1 button.
  3. (Improved V-Log L setting issue of firmware Ver.2.3. This was corrected and there are no changes in the above-mentioned functions.)

AG-YAGH - Ver 1.1

Following functions are available to support the upgrade of GH4 firmware ver.2.1.

  1. Timecode can be embedded to the HDMI output signal.
    *Available when AG-GH4 or AG-YAGH are connected with the products of ATOMOS Global Pty. Ltd. or the products complying with the extended specifications of ATOMOS Global Pty. Ltd..
  2. RSS (Recording Start/Stop) signal can be embedded to the HDMI output signal.
    *Available when AG-GH4 or AG-YAGH are connected with the products of ATOMOS Global Pty. Ltd. or the products complying with the extended specifications of ATOMOS Global Pty. Ltd..
  3. FHD at 30p/25p native output via HDMI is available while recording video in FHD at 30p/25p.
  4. FHD at 30PsF / 25PsF output via SDI is available while recording video in FHD at 30p/25p.

Download the latest Firmware and Software

Also Consider

Blackmagic Design ATEM 1ME Production Studio 4K
Blackmagic Design ATEM 1ME Production Studio 4K

1 M/E production switcher with 8 inputs, DVE, 9 layers for Mac and PC.
[BMDSWATEMPSW1ME]

Back to Top

Cookies

We use cookies to help us offer you the best online experience. By continuing to use our website/or clicking Accept, you consent to the use of cookies in accordance with our privacy policy.