AK-HRP1000
Firmware Version:
SYSTEM VERSION: 4.82-00-0.05
SOFT VERSION: .82-00-0.05
FPGA VERSION: 1.01-00-0.00
- New studio camera AK-UC3300 can be controled.
- Enhance of the control function of AK-UC4000 Menus have been added to set the non-linear matrix and color adjustment function.
- Camera recorder AJ-CX4000 (Ver.3.04 or later) can be controled. (Supplementary material: Operating guide)
- The account setting specifications have been changed so that the AJ-CX4000 can be used.
You can set an account for each "camera number".
(Originally, it was a specification to set only one common account for multiple cameras.)
"Setup software" has been changed to the same specifications.
SYSTEM VERSION - 4.60-00-0.00
SOFT VERSION - 4.60-00-0.00
FPGA VERSION - 1.01-00-0.00
- Controlling AJ-PX5000 camcorder via serial connection using AK-HRP1000 is enabled.
- Linkage with AV-HS6000
AV-HS6000 communicates with ROP when TALLY is turned ON/OFF at AV-HS6000. ROP communicates TALLY (RED) information to the configured camera.
Linking the Unit to the AV-HS6000
Please refer to the "Linking the Unit to the AV-HS6000" for details.
Related Plug-in: "External Control"
This is a function available when equipment other than studio cameras is connected. (VariCamLT, etc.)
- Linkage with AV-HS6000
ROP communicates with AV-HS6000 when Preview button on ROP’s PANEL is pressed.
When AV-HS6000 receives the information, it runs the macro recorded via "Macro Trigger IP" plugin to execute BUS switching, etc.
Linking the Unit to the AV-HS6000
Please refer to the "Linking the Unit to the AV-HS6000" for details.
Related Plug-in: "Macro Trigger IP"(new plug-in)
This is a function available when equipment other than studio cameras is connected. (VariCamLT, etc.)
- HS format is suppurted.
Correction is made so that FORMAT RATE command is sent together when, from ROP and MSU, FORMAT commands are sent to the camera and CCU.
(No change in menu indications. Correction to the internal control only.)
- The following item is added to HDR PAINT menu.
SDR CONVERT : ”BLACK”(BLACK OFFSET)
However, this parameter is available for AK-UC4000 only, and shown as “ー” on the others.
- A menu is added so that TALLY input can be checked at the contact point.
This is for making this check possible with ROP only without the camera
This is a function available when equipment other than studio cameras is connected. (VariCamLT, etc.)
SYSTEM CAM : TALLY SIGNAL
Download the latest Firmware and Software